TPG-431-UEN-DNP25GT/ TPG-220404-UEN-DNP25GT, HP-High Performance 7° ISO Insert, For General Application, Wear & Impact Resistant, PVD Single Layer Coating, Low Cutting Speed, Small Depth of Cut and Low Feed per Rev, Light interrupted Cut, For Aluminum, Stainless Steel, Hardened Steel, Wet Working Condition, Sold in (Pack of 5)
Details
Chip Breaker Info:
UEN, Ground surface, no Chip Breaker, negative Rake Angle, honed Cutting Edge, For General Turning Application, of Ferrous and non Ferrous Materials, at Small Depth of Cut (ap) and Feed Rate per Revolution (fn)
compatible_devices:
CTAPL16-4D, CTAPL85-4D, CTAPR16-4D, CTAPR85-4D, CTFPL12-4B, CTFPL16-4C, CTFPL16-4D, CTFPL20-4D, CTFPL85-4D, CTFPR12-4B, CTFPR16-4C, CTFPR16-4D, CTFPR20-4D, CTFPR85-4D, CTGPL16-4C, CTGPL16-4D, CTGPL20-4D, CTGPL85-4D, CTGPR16-4C, CTGPR16-4D, CTGPR20-4D, CTGP
Detailed Grade Info:
The DNP25GT grade, it is a hard and tough micro-grained substrate, with shock resistant cutting edge for uneven cutting surface. PVD TiN coated, for General Turning Application, of Aluminum, and non Ferrous Metals, Plastic and Hardened Steel, at High SFM (
First Choice Application:
First Choice: For General Application of Aluminum, Stainless Steel, Hardened Steel, with Small Depth of Cut and Low Feed per Revolution at Low SFM (Vc), Light interrupted Cut, Wet Working Condition
For workpiece materials:
Aluminum, Stainless Steel, Hardened Steel
Grade Info:
PVD TiN coated, hard and tough micro-grained substrate, with shock resistant cutting edge for uneven cutting surface. For turning Aluminum, and non Ferrous Materials
