TNU-433-UEN-DKU25GT/ TNU-220412-UEN-DKU25GT, HP-High Performance Negative Turning Insert, For General Application, Wear & Impact Resistant, Uncoated, Medium Cutting Speed, Small Depth of Cut and Low Feed per Rev, Light interrupted Cut, For Cast Iron, Hardened Steel, Non-Ferrous, Wet/Dry Working Condition, Sold in (Pack of 5)
Details
Chip Breaker Info:
UEN, Ground Surface, no Chip Breaker, Negative Rake Angle, Small Honed Cutting Edge, For General Turning Application, Ferrous and non Ferrous Materials, at Small Depth of Cut (ap) and Feed Rate per Revolution (fn)
compatible_devices:
MTANL16-4D, TANL20-4D, MTANL85-4D, MTANL86-4E, MTANR16-4D, MTANR20-4D, MTANR85-4D, MTANR86-4E, MTCNN12-4B, MTCNN64-4D, MTCNN64-4F, MTCNN66-4E, MTCNN66-4F, MTENN12-4B, MTENN16-4D, MTENN85-4D, MTENN86-4E, MTFNL16-4C, MTFNL16-4D, MTFNL20-4D, MTFNL24-4E, MTFNL
Detailed Grade Info:
The DKU25GT uncoated grade with a hard, tough, wear and abrasive resistant substrate. Medium Cutting Speed, for General Turning Application, from Finishing to Roughing. To cut Carbon Steel, Alloy Steel and Stainless Steel at Medium SFM (Vc) for Light inte
First Choice Application:
First Choice: For General Application of Cast Iron, Hardened Steel, Non-Ferrous, with Small Depth of Cut and Low Feed per Revolution at Medium SFM (Vc), Light interrupted Cut, Wet/Dry Working Condition
For workpiece materials:
Cast Iron, Aluminum, Hardened Steel, Non-Ferrous
Grade Info:
CVD, Multi Layer of Alumina, Titanium Carbonitrede Coating , for Medium speed turning of Carbon and Alloy Steel, Stainless Steel
